Tutorial
How to set up my audio capture properties?
FastCap game recorder supports recording sync audio and video. Just enable "Record Sound" (in Box 2) to capture audio. If you still can not capture audio with "Record Sound" enabled, just following the following steps:
 |
1. Click the main page. 2. Check whether "Record Audio" has been enable (in Box 2 ). |
 |
3. Click on "Audio" page ( Box 3 ). 4. Set up audio compression in Box 4 if need. 5. Check whether you are using the correct sound card (the sound card you currently use) If you have two sound cards, there will be two selection lines in the box 5 ("NVIDIA(R) nForce(TM) Audio" and "Creative Sound Blaster PCI" ), just go to your control panel, open "Sound and Audio Devices" dialog box as shown below. Make sure the Audio Device used by FastCap are the one used by your system.(Just as shown below, we choose the same audio card "NVIDIA(R) nForce(TM) Audio" in all Box 5 .
|
 |
|
| 6. Click on "Sound Volume" button in the "Audio" page, open the dialog as shown below, then Click "Enable" to enable audio input ( Box 6 ). | |
 |
|
7. Choose "Input Pin Line" in Box 7 . If you are going to record the sound your computer displays, please choose "Stereo Mix" (Box 7) . 8. Adjust the slider in Box 8 to set up sound volume . 9 Click "OK" to complete setting! |
Click to view the picture...
